Daikin Quaternity H-Series Specifications Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 80
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
Installation Manual EDUS04-906_b
24 Room Air Conditioners H-Series
4
Installation Tips
1.
Removing and installing front panel.
Removal method
1) Open the front panel.
2) Spread out the shaft hole on the left side and
remove the rotating shaft.
Spread out the shaft hole on the right side as well
and remove the rotating shaft.
Installation method
Insert the right and left rotating shafts on the front
panel into the shaft holes one at a time and slowly
close the panel.
(Press on both sides of the front panel.)
2.
Removing and installing the upper panel.
Removal method
1) Remove the front panel and air filter.
2)
Hold and pull forward 2 tabs on both sides to discharge them,
discharge the center tab, and then lift up the upper panel.
Installation method
1) Push in the upper panel along the guide on the top of the
front grille and insert the 3 tabs into the slots on the front
grille.
2) Push the upper panel down until it clicks.
3) Attach the air filter and front panel.
3.
Removing and installing the front grille.
Removal method
1) Remove the front panel, air filter and upper panel.
2)
Fully open the top and bottom horizontal louvers. (See Fig. 1)
3) Remove the 3 screws in the front grille.
4) Lift the hooks (3 locations) on the front grille with a flathead
screwdriver to discharge the tab.
(Look for the mar

k.) (See Fig. 2)
5) Pull forward the front grille to remove.
Installation method
1) Open the top louver fully and close the bottom louver fully.
2) Store the gear case arm in the front grille. (See Fig. 3)
3) Attach the front grille to the lower part of the unit.
(Use caution not to pinch the horizontal louver.)
4) Make sure to firmly latch the top hooks (3 locations).
5) Tighten with the 3 front grille screws.
6) Attach the upper panel, air filter and front panel.
Rotating shaft
Shaft hole
Rotating shaft
Shaft hole
Rotating shaftShaft hole
Tabs
(2 on both sides)
Tab (Center)
Tabs (3 locations)
Fig. 1
Horizontal louver
When removing or
attaching the front grille,
pay attention to open or
close of each horizontal
louver.
Bottom horizontal louver
Top horizontal louver
Upper panel
mark area (3 locations)
mark area (3 locations)
Fig. 2
Hooks on the front grille
CAUTION
Use caution to prevent the
front grille from breaking.
Gear case arm
Be sure to
store the
gear case
arm before
attaching the
front grille.
Fig. 3


Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 79 80

Comments to this Manuals

No comments