Daikin BRC7E61W Service Manual download pdf (Page 58)

SiE25-110 Method of Field Set (Reset after Maintenance Inspection/Repair)

Field Setting 49

1.5.9 Wireless Setting (Address and MAIN/SUB Setting)

Explanation If several wireless remote controller units are used together in the same room (including the

case where both group control and individual remote controller control are used together), be

sure to set the addresses for the receiver and wireless remote controller. (For group control, see

the attached installation manual for the indoor unit.) If using together with a wired remote

controller, you have to change the main/sub setting or the receiver.

Setting The

Receiver

Through the small opening on the back of the receiver, set the wireless address switch (SS2) on

the printed circuit board according to the table below.

When using both a wired and a wireless remote controller for 1 indoor unit, the wired controller

should be set to MAIN. Therefore, set the MAIN/SUB switch (SS1) of the receiver to SUB.

After completing setting, seal off the opening of the address switch and the MAIN/SUB switch

with the attached sealing pad.

Unit No. No.1 No.2 No.3

Wireless Address

Switch (SS2)

MAIN SUB

MAIN/SUB Switch

(SS1)

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 254 255

No comments

Daikin BRC7E61W Service Manual Page 58