SiEBE12-625 Instruction
List of Functions 115
Outdoor Unit
Indoor Unit
Outdoor Unit
Appearance of the outdoor unit may differ from some models.
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter
• These filters are attached to the inside of
the air filters
3. Air inlet
4. Front panel
5. Supporting plate:
• The supporting plate is used to support the
front panel during maintenance.
6. Panel tab
7. Flap (horizontal blade)
8. Air outlet
9. Louvers (vertical blades)
• The louvers are inside of the air outlet.
10. Outlet vent panel
11. Display
12. Indoor unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
• The operation mode refer to the following
table.
• This switch is useful when the remote
control is missing
13. Room temperature sensor:
• It senses the air temperature around the unit
14. Operation Lamp (green)
15. TIMER lamp (yellow)
16. INTELLIGENT EYE lamp (green)
17. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal
operation and energy saving operation.
18. Signal receiver:
•I
t receives signals from the remote controller.
• When the unit receives a signal, you will
hear a short beep
• Operation start ...........beep-beep
• Settings changed .......beep
• Operartion stop ..........beeeeep
19. Air inlet:
(Back and side)
20. Air outlet
21. Refrigerant piping and inter-unit cable
22. Drain hose
23. Earth terminal
• It is inside of this cover.
Mode Temperature
setting
Air flow
rate
FTXS AUTO 25°C AUTO
Comments to this Manuals