Daikin FTXG25EV1BS Service Manual Page 247

  • Download
  • Add to my manuals
  • Print
  • Page
    / 323
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 246
SiEBE12-625 Troubleshooting
Service Diagnosis 237
5.26 Low-voltage Detection
Remote
Controller
Display
U2
Outdoor Unit LED
Display
A 5 1 4 2 1 3 1 4 4
Method of
Malfunction
Detection
An abnormal voltage rise or drop is detected by checking the detection circuit or DC voltage
detection circuit.
Malfunction
Decision
Conditions
An over-voltage signal is fed from the over-voltage detection circuit to the microcomputer, or
the voltage being detected by the DC voltage detection circuit is judged to be below 150 V
for 0.1 second.
The system will be shut down if the error occurs 16 times.
Clearing condition: Continuous run for about 60 minutes (normal)
Supposed
Causes
Supply voltage not as specified
Over-voltage detector or DC voltage detection circuit defective
PAM control part(s) defective
Troubleshooting
Check the supply voltage.
Correct the power supply.
Check for such factors for a
long term.
Try to get restarted a
couple of times.
Replace the SPM.
(Replace the outdoor unit
PCB.)
(R2854)
Caution
Be sure to turn off power switch before connect or disconnect connector,
or parts damage may be occurred.
Supply voltage as
specified?
NO
YES
Turn on the power again.
System restarted?
NO
YES
Disturbance factors
Noise Power supply distortion
Repeat a couple
of times.
(Precaution before turning on the power again)
Make sure the power has been off for
at least 30 seconds.
Page view 246
1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 322 323

Comments to this Manuals

No comments