
4 English
Accessories2.
The following accessories are included.
Wood screw Small screw Clamp
Operation
manual
Installation
manual
Wiring retainer
(φ3.5×16mm)
(M4×16mm)
(2 pcs.) (2 pcs.) (1 pc.) (1 pc.) (1 pc.) (1 pc.)
Remote controller installation procedure
3.
Determine where to install the remote controller.3-1
Make sure to follow the Safety Considerations when determining the location.
If the control cable for the remote controller is to be routed 3-2
from the rear, make a hole in the wall taking into consideration
the location of the access hole in the lower case.
Align the center of the wall
hole with the center of the
access hole on the controller
lower case when planning the
installation.
F5/16-3/8
External view of the remote controller
Access
hole
F5/16-3/8
Lower case
Through-hole
1-15/16
1-9/16
Remove upper case. 3-3
Insert a screwdriver in the recess of lower case to remove the upper case (2 points).
Upper case
Lower case
Screwdriver
Insert and twist the screwdriver
lightly for removal.
Remote controller PC-board is
installed on the upper case. Take care
not to damage the PC-board with the
screwdriver.
Take care that dust or moisture does
not touch the PC-board.
If the hole size is too large or not in the proper
location, it may be seen after the remote
controller is installed.
NOTE
01_EN_3P243521-3D.indd 401_EN_3P243521-3D.indd 4 9/13/2012 7:22:16 PM9/13/2012 7:22:16 PM
Comments to this Manuals