Daikin BRC1E51A7 Installation Manual download pdf (Page 4)

2 English

• Make sure that a separate power supply circuit is provided for this unit and that all electrical work is carried

out by qualified personnel according to local laws and regulations and this installation manual.

An insufficient power supply capacity or improper electrical construction may lead to electric shocks or fire.

• Make sure that all wiring is secured, the specified wires are used, and that there is no strain on the ter-

minal connections or wires.

Improper connections or securing of wires may result in abnormal heat build-up or fire.

• When wiring the power supply and connecting the wiring between the indoor and outdoor units, position

the wires so that the control box lid can be securely fastened.

Improper positioning of the control box lid may result in electric shocks, fire or overheating terminals.

• If refrigerant gas leaks during installation, ventilate the area immediately.

Toxic gas may be produced if the refrigerant comes into contact with fire.

• After completing installation, check for refrigerant gas leakage.

Toxic gas may be produced if the refrigerant gas leaks into the room and comes into contact with a source

of fire, such as a fan heater, stove or cooker.

• Be sure to switch off the unit before touching any electrical parts.

• Do not directly touch refrigerant that has leaked from refrigerant pipes or other areas, as there is a danger

of frostbite.

• Be sure to earth the air conditioner.

Do not earth the unit to a utility pipe, lightning conductor or telephone earth lead.

Imperfect earthing may result in electric shocks or fire.

A high surge current from lightning or other sources may cause damage to the air conditioner.

• Be sure to install an earth leakage breaker.

Failure to install an earth leakage breaker may result in electric shocks or fire.

CAUTION

• While following the instructions in this installation manual, install drain piping to ensure proper drainage and

insulate piping to prevent condensation.

Improper drain piping may result in indoor water leakage and property damage.

• Install the indoor and outdoor units, power cord and connecting wires at least 1 meter away from televisions

or radios to prevent picture interference and noise.

(Depending on the incoming signal strength, a distance of 1 meter may not be sufficient to eliminate noise.)

• Remote controller (wireless kit) transmitting distance can be shorter than expected in rooms with electronic

fluorescent lamps (inverter or rapid start types).

Install the indoor unit as far away from fluorescent lamps as possible.

• Do not install the air conditioner in the following locations:

1. Where there is a high concentration of mineral oil spray or vapour (e.g. a kitchen).

Plastic parts will deteriorate, parts may fall off and water leakage could result.

2. Where corrosive gas, such as sulphurous acid gas, is produced.

Corroding of copper pipes or soldered parts may result in refrigerant leakage.

3. Near machinery emitting electromagnetic radiation.

Electromagnetic radiation may disturb the operation of the control system and result in a malfunction of

the unit.

4. Where flammable gas may leak, where there is carbon fibre or ignitable dust suspensions in the air, or

where volatile flammables such as paint thinner or gasoline are handled.

Operating the unit in such conditions may result in fire.

• The air conditioner is not intended for use in a potentially explosive atmosphere.

1 2 3 4 5 6 7 8 9 ... 31 32

Comments to this Manuals

No comments

Daikin BRC1E51A7 Installation Manual Page 4

Comments to this Manuals

Related products and manuals for Remote controls Daikin BRC1E51A7