Daikin BRC1E51A7 Installation Manual download pdf (Page 25)

English 23

Wiring Method (See ‘‘8. ELECTRIC WIRING WORK’’)

(3) Remove the control box lid

(4) Add remote controller 2 (slave) to the terminal block for remote controller (P

, P

) in the control

box. (There is no polarity.) (Refer to Fig. 33 and Table 4)

NOTE

All transmission wiring except for the remote controller wires is polarized and must match the terminal symbol.

2. In case of group control, perform the remote controller wiring to the master unit when connecting to the

simultaneous operation system. (wiring to the slave unit is unnecessary)

3. For group control remote controller, choose the remote controller that suits the indoor unit which has the

most functions (as attached swing flap)

10. INSTALLATION OF THE DECORATION PANEL

• Refer to the installation manual attached to the decoration panel.

• After installing the decoration panel, ensure that there is no space between the unit body and decoration

panel.

• When making a test run before installation of the decoration panel, be sure to check the operation of the

swing flap after the installation.

11. FIELD SETTING

• Be sure to check that the outdoor unit has been wired.

• Make sure the control box lids are closed on the indoor and outdoor units.

• Setting can be made by changing the “Mode No”, “FIRST CODE NO.” and “SECOND CODE NO.”.

• For setting procedures and instructions, see “Field settings” provided with the remote controller.

*Settings are done in a batch for the group. To make or confirm settings for an individual unit, set the Mode

No. shown in parentheses.

• Do not set numbers unless mentioned in the table.

11-1 Setting ceiling height

• Select the SECOND CODE NO. that corresponds to the ceiling height “Table 5”.

(SECOND CODE NO. is factory set to “01” for a ceiling height of less than 2.7m.)

Upper part of

remote controller

Lower part of

remote controller

Insert the screwdriver

here and gently work

off the upper part of

remote controller.

Remote

controller

PC board

(Factory setting)

(Only one remote

controller needs

to be changed if

factory settings

have remained

untouched.)

Fig. 36

Fig. 35

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Daikin BRC1E51A7 Installation Manual Page 25

Comments to this Manuals

Related products and manuals for Remote controls Daikin BRC1E51A7