32
CARE
Care and Cleaning
■
Indoor unit, outdoor unit and remote controller
1. Wipe them with dry soft cloth.
■
Front panel
1. Open the front panel.
• Hold the front panel by the panel tabs on the
both sides and open it.
2. Remove the front panel.
• Slide the front panel to either the left or right and
pulling it toward you.
This will disconnect the rotation dowel on one side.
• Disconnect the front panel shaft on the other side in
the same manner.
3. Clean the front panel.
• Wipe it with a soft cloth soaked in water.
• Only neutral detergent may be used.
• In case of washing the panel with water, wipe it with
dry soft cloth, dry it up in the shade after washing.
4. Attach the front panel.
• Align the front panel shaft on the left and right of the
front panel with the slots, then push them all the way
in.
• Close the front panel slowly.
(Press the panel at both sides and the center.)
CAUTION
CAUTION
Before cleaning, be sure to stop the operation and
turn the breaker off.
Units
• Don’t touch the metal parts of the indoor unit. If you touch those parts, this may cause an
injury.
• When removing or attaching the front panel, use a robust and stable stool and watch your
steps carefully.
• When removing or attaching the front panel, support the panel securely with hand to prevent
it from falling.
• For cleaning, do not use hot water above 40°C, benzine, gasoline, thinner, nor other volatile
oils, polishing compound, scrubbing brushes, nor other hand stuff.
• After cleaning, make sure that the front panel is securely fixed.
1) Slide
2) Pull
Fit the key
into the slot.
Slot
Front panel
shaft
01_EN_3P248442-3.fm Page 32 Tuesday, September 8, 2009 1:54 PM
Comments to this Manuals