Daikin FHQ125CAVEB Installation Manual download pdf (Page 8)

7 English

(3) Remove the parts of the indoor unit.

1) Remove the suction grille.

• Slide the suction grille fixing knobs (35, 50 type: 2 places for each, 60~140 type: 3 places for each)

toward backward direction (as shown by an arrow) to open the suction grille widely. (Refer to Fig. 4)

• Keeping the suction grille opened, hold the knob at the back of the suction grille and at the same

time, pull the suction grille forward to remove. (Refer to Fig. 5)

2) Remove the decoration side panel (right, left).

• Remove the fixture screw of the decoration side panel (one for each), pull forward (arrow direction)

to remove. (Refer to Fig. 6)

• Take out accessories. (Refer to Fig. 6)

• Open the knock hole at the wiring inlet side at the rear surface or top surface, and install the attached

resin bushing (10).

3) Remove the hanger.

• Loosen 2 bolts for installing the hanger at both sides (M8) (4 places at left and right) within 10mm.

(Refer to Fig. 7 and Fig. 8)

• Remove the fixture screw for hanger at the back side (M5), pull the hanger backward (the arrow

direction) to remove. (Refer to Fig. 8)

Fig. 4 Fig. 5

Fixing knob

Suction grille

Rear knob

Resin bushing (10)

(accessory)

Removable part (for leading in

from the upward-facing)

Resin bushing (10)

(accessory)

Removable part (for leading in

from the rear-facing)

Fig. 6

Fixing screw for decoration

side Panel

(M4)

Decoration side panel

Accessories

Fig. 7 Fig. 8

Bolt (M8)

Indoor unit

Hanger fixing

screw (M5)

Hanger

installing bolt

(M8)

Hanger

Loosen

Hanger

Loosen within

10mm

01_EN_3P249378-6L.fm Page 7 Sunday, September 30, 2012 2:30 PM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Comments to this Manuals

No comments

Daikin FHQ125CAVEB Installation Manual Page 8

Comments to this Manuals

Related products and manuals for Split-system air conditioners Daikin FHQ125CAVEB