Daikin FHQ125CAVEB Installation Manual download pdf (Page 17)

English 16

• Make sure to use the attached drain hose (1) and metal clamp (2). Also, insert the drain hose (1) into the

root of the drain socket, and tighten the metal clamp (2) at the root of the drain socket tightly.

(Refer to Fig. 25 and Fig. 26)

(Install the metal clamp (2) so that the tightening part is in the range of about 45°as shown in the Fig. 26.)

(Do not bond the drain socket and drain hose. If so, maintenance and inspection for the heat exchanger

and others cannot be conducted.)

CAUTION

If an old drain hose or an elbow or a clamp is used, it may cause water leakage.

• Bend the tip of the metal clamp (2) so that the sealing material does not bulge. (Refer to Fig. 26)

• When performing insulation, wind the large sealing material (Large) (8) attached starting from the base

of the metal clamp (2) and drain hose (1) in the direction of the arrow. (Refer to Fig. 25 and Fig. 26)

• Be sure to insulate all drain piping running indoors.

• Do not deflect the drain hose (1) inside of the indoor unit. (Refer to Fig. 27)

(It may cause abnormal noise such as bubbling noise.)

(If the drain hose (1) is deflected, it may damage the suction grille.)

• Install supports at a distance of 1 to 1.5m so that the piping may not deflect. (Refer to Fig. 23)

CAUTION

To prevent dust from entering the indoor unit, cover the gap with the drain piping by putty or insulation

(field supply) so that no clearance is made.

However, when putting piping and remote controller wiring through the same hole, cover the gap between

the through cover and the piping after ‘‘8. ELECTRIC WIRING WORK’’ is completed.

Sealing material (Large) (8)

(accessory)

Metal clamp (2)

(accessory)

Drain hose (1)

(accessory)

Fig. 25

Do not make a gap to avoid

dew condensation.

Tightening

part

Sealing material

(Large) (8)

(accessory)

Sealing material

(Large) (8)

(accessory)

Metal clamp (2)

(accessory)

Metal clamp (2)

(accessory)

Drain hose (1)

(accessory)

Drain hose (1)

(accessory)

(For left rear/

left side)

(For right back/

right side)

Inserting direction

for the screw driver

approx. 45˚

Sealing material

(Large) (8)

Applying direction

Fig. 26

Bend the tip without

tearing the sealing

material (Large) (8)

Do not deflect

Fig. 27

01_EN_3P249378-6L.fm Page 16 Sunday, September 30, 2012 2:30 PM

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Comments to this Manuals

No comments

Daikin FHQ125CAVEB Installation Manual Page 17

Comments to this Manuals

Related products and manuals for Split-system air conditioners Daikin FHQ125CAVEB