English 3
2.
WHAT TO DO BEFORE OPERATION
This operation manual is for the following systems with stan-
dard control. Before initiating operation, contact your Daikin
dealer for the operation that corresponds to your system type
and mark.
If your installation has a customized control system, ask your
dealer for the operation that corresponds to your system.
2-1 NAMES OF PARTS (Refer to figure 1)
(1) Hanger bracket
(2) Duct connecting flange
(3) Exhaust fan
(4) Air filter
(5) Damper
(6) Control box
(7) Service cover
(8) Heat exchanger core
(9) Nameplate
(10)Supply air fan
(11)Remote controller (Optional accessory)
(12)Damper motor
(13)EA Exhaust air to outside
(14)OA Outdoor air from outside
(15)Service space for the air filter, the heat exchanger core and
control box.
(16)RA Return air from inside
(17)SA Supply air to inside
2-2 BUTTON LOCATIONS AND DESCRIPTIONS OF
REMOTE CONTROLLER
1. Operation mode selector button
2. Fan speed control button
3. Menu/OK button
4. Up button
5. Down button
6. Right button
7. Left button
8. On/Off button
9. Operation lamp
10. Cancel button
11. LCD (with backlight)
Functions other than basic operation items (i.e., On/Off,
Operation mode selector, Fan speed control, and tempera-
ture setpoint) are set from the menu screen.
NOTE
• Do not install the remote controller in places exposed to
direct sunlight, otherwise the LCD will be damaged.
• Do not pull or twist the remote controller wire, otherwise the
remote controller may be damaged.
• Do not use objects with sharp ends to press the buttons on
the remote controller, otherwise damage may result.
1 Operation mode selector button
•
Press this button to select the operation mode of your
preference.
*Available modes vary with the indoor unit model.
2 Fan speed control button
•
Press this button to select the fan speed of your prefer-
ence.
*Available fan speeds vary with the indoor unit model.
3 Menu/OK button
•
Used to indicate the main menu.
For details, refer to the operation manual attached to the
remote contoller.
•
Used to enter the selected item.
4 Up button
•
Used to raise the setpoint.
•
The item above the current selection will be highlighted.
(The highlighted items will be scrolled continuously
when the button is continuously pressed.)
•
Used to change the selected item.
5 Down button
•
Used to lower the setpoint.
•
The item below the current selection will be highlighted.
(The highlighted items will be scrolled continuously
when the button is continuously pressed.)
•
Used to change the selected item.
6 Right button
•
Used to highlight the next items on the right-hand side.
•
Each screen is scrolled in the right-hand direction.
7 Left button
•
Used to highlight the next items on the left-hand side.
•
Each screen is scrolled in the left-hand direction.
8 On/Off button
•
Press this button and system will start.
•
Press this button again to stop the system.
9 Operation lamp (Green)
•
This lamp illuminates solid during normal operation.
•
This lamp blinks if a error occurs.
10 Cancel button
•
Used to return to the previous screen.
11 LCD (with backlight)
•
The backlight will be illuminated for approximately 30
seconds by pressing any button.
•
If two remote controllers are used to control a single
indoor unit, only the controller to be accessed first will
have backlight functionality.
On/Off
Mode
Fan
Speed
Cancel
Menu
OK
1
2310
11 9 84, 5, 6, 7
Comments to this Manuals