Daikin FTXS100KVMA Installation Manual

OPERATION MANUALCENTRAL REMOTE CONTROLLERMODELSDCS302CA61Read these instructions carefully before installation. Keep this manual in a handy place for

9 English• If the zone number in the zone screen is dis-played as “---,” this indicates that no units are registered in a zone.Please perform zone reg

English 102. Select the Zone Number to be regis-tered using the “ZONE NUMBER” button.Keeping the button pressed down will move it rapidly.3. “” to the

11 English䡲䡲䡲䡲 Changing the fan direction and fan strength (Fig. 8)This changes the fan direction and strength settings in the air conditioner.Changin

English 123. Select the desired timer number by pressing the “TIMER NO.” button.Once the desired timer number is displayed, press the “SET” button.Th

13 EnglishOPERATION MODEThe following five operation control modes can be selected along with the temperature setting and operation mode by remote con

English 14Note) Do not select the timer operation possible without the remote controller. In this case, timer operation is disabled.EXAMPLE OF OPERAT

15 EnglishRemotecontrollerCentralizedCentralizedRemotecontrollerCentralizedRemotecontrollerCentralizedCentralizedRemotecontrollerCentralizedRemotecont

English 16䡲䡲䡲䡲 Setting operation mode (Fig. 12)[Registration]1. Press the OPERATION MODE SELEC-TOR BUTTON. Each time you press this button, the displ

17 EnglishWhen in zone screenThe zone screen will revert to the individual screen automatically if nothing is done in it for one minute.[Registration]

English 18C4Indoor unit · Liquid piping thermistor (Th2) Error (faulty connec-tion, cut wire, short circuit, fault)C5Indoor unit · BEV unit, gas pipin

1 EnglishBEFORE USE䡲䡲䡲䡲 GENERAL DESCRIPTION OF SYSTEMThis central remote controller can monitor and control up to 64 indoor unit groups.Using two cent

19 English error codes (in outline font) do not display “maintenance” and the system will run, but please check the content of the display and contact

English 20䡲䡲䡲䡲 Setting master remote controller (Fig. 15)You must set the master remote controller of the oper-ation mode for one of the indoor units,

21 EnglishCall the unit whose system you wish to look up using the arrow keys.The “ ” on all groups in the same system as the displayed group will lig

English 22INSTALLATION TABLEWhen installing the equipment, mark the zone No. of each group and installation location in the below table.Setting group

23 EnglishOPTIONAL ACCESSORIESDOUBLE CENTRAL REMOTE CONTROLLERSNote)• For control alignment and settings for double central remote controllers, contac

English 24SPECIFICATIONS䡲䡲䡲䡲 Specifications䡲䡲䡲䡲 Outline drawingsWhen using this unit an electric parts box of KJB311AA is required.For installation, a

English 25Fig. 9Fig. 12Fig. 10Fig. 11165423

English 26Fig. 14Fig. 13Fig. 16Fig. 15

3P124623-8D EM05A046(0510) HT

English 2∗ Zone control from the central remote controllerZone control is available from the central remote controller. With it, it is possible to ma

3 EnglishFig. 1Fig. 3Fig. 2Fig. 4

4 EnglishFig. 6Fig. 5Fig. 8Fig. 7

5 EnglishCAUTIONAfter a long use, check the unit stand and fittingfor damage.If they are left in a damaged condition, the unit may fall and result in

English 6FEATURES AND FUNCTIONS• Room air conditioners and multi-purpose air conditioners may also be connected by using separately-sold adapter board

7 EnglishNAMES AND FUNCTIONS OF THE OPERATING SECTION (Fig. 1, 2)1UNIFIED OPERATION BUTTONPress to operate all indoor units.2UNIFIED STOP BUTTONPress

English 8OPERATION䡲䡲䡲䡲 Individual screen, all screen, zone screen (Fig. 3)This controller can perform operations in the individual screen, all screen,