• Read these Safety Precautions carefully to ensure correct installation.• This manual classifies the precautions into DANGER, WARNING and CAUTION. Be
How to Use ReducersPump Down Operation● When using the reducer packing shown above, be careful not to overtighten the nut, or the smaller pipe may be
Lock nutConduitConduitmounting plateKnockout holeForced OperationWiring (1) 1) Turn the Operation Mode switch (SW2) to “COOL.” 2) Press the Forced Ope
Room ARoom CRoom DRoom Bpower supplyWiring (2)Stranded wireRound crimp-styleterminalWhen connecting the connection wires to the terminal board using a
Priority Room Setting● To use Priority Room Setting, initial settings must be made when the unit is installed. Explain the Priority Room Setting, as d
Night Quiet Mode settingCOOL/ HEAT mode lock <S15>● If Night Quiet Mode is to be used, initial settings must be made when the unit is installed.
Test Run and Final Check (1) 1) For two rooms, LED 3 and 4 are not displayed, and for three rooms, LED 4 is not displayed. 2) If the outside air tempe
3P207257-3 M07B061Test Run and Final Check (2)● Have the customer actually operate the unit while looking at the manual included with the indoor unit
• Installation should be left to the authorized dealer or another trained professional. Improper installation may cause water leakage, electrical shoc
Accessories supplied with the outdoor unit:AccessoriesPrecautions for Selecting the Location(A) Installation Manual(C) Reducer assy(B) Drain socket as
Indoor/Outdoor Unit Installation DrawingsFor installation of the indoor units, refer to the installation manual which was provided with the units.(The
Installation4MXS32∗ – Up to 45000 Btu● Install the unit horizontally.● The unit may be installed directly on a concrete verandah or a solid place if d
Outdoor Unit Installation GuidelinesSelecting a Location for Installation of the Indoor Units● The maximum allowable length of refrigerant piping, and
Refrigerant Piping Work (1)1 Installing Outdoor Unit● When installing the outdoor unit, refer to “Precautions for Selecting the Location” and the “Ind
Refrigerant Piping Work (2)4 Purging Air and Checking Gas Leakage● When piping work is completed, it is necessary to purge the air and check for gas l
Refrigerant Piping Work (3)WallIf no flare cap is available, cover the flare mouth with tape to keep dirt or water out.Be sure to place a cap.RainGas
Comments to this Manuals