Daikin BRC7E61W User Manual download pdf (Page 7)

Remote Controller (Wireless Type) OH08-1

34 Control Systems

3PA63363-24W-6

 FAN OPERATION....................... “ ”

 DRY OPERATION ...................... “ ”

•

See “FOR SYSTEM WITHOUT COOL/

HEAT CHANGEOVER REMOTE CON-

TROL SWITCH” for details on dry opera-

tion.

(2) Press OPERATION MODE SELECTOR

button several times and select “ ”

(This operation is only available during

dry operation.)

ON/OFF

Press ON/OFF button

OPERATION lamp lights up or goes off and

the system starts or stops OPERATION.

NOTE

•

Do not turn OFF power immediately after

the unit stops. Then, wait no less than

5 minutes.

Water is leaking or there is something else

wrong with the unit.

[EXPLANATION OF HEATING OPERA-

TION]

DEFROST OPERATION

•

As the frost on the coil of an outdoor unit

increase, heating effect decreases and the

system goes into DEFROST OPERATION.

•

The fan operation stops and the

DEFROST lamp of the indoor unit goes on.

After 6 to 8 minutes (maximum 10 min-

utes) of DEFROST OPERATION, the sys-

tem returns to HEATING OPERATION.

Heating capacity & Outdoor air

temperature

•

Heating capacity drops as outdoor air tem-

perature lowers. If feeling cold, use

another heater at the same time as this air

conditioner.

2

ON OFF

•

Hot air is circulated to warm the room. It

will take some time from when the air con-

ditioner is first started until the entire room

becomes warm. The internal fan automat-

ically turns at low speed until the air condi-

tioner reaches a certain temperature on

the inside. In this situation, all you can do

is wait.

•

If hot air accumulates on the ceiling and

feet are left feeling cold, it is recommended

to use a circulator. For details, contact the

place of purchase.

For programming TEMPERATURE, FAN

SPEED and AIR FLOW DIRECTION, follow

the procedure shown below.

TEMPERATURE SETTING

Press TEMPERATURE SETTING but-

ton and program the setting tempera-

ture.

Each time this button is pressed,

setting temperature rises 1°C.

Each time this button is pressed,

setting temperature lowers 1°C.

In case of automatic operation

Each time this button is pressed,

setting temperature shifts to “H”

side.

Each time this button is pressed,

setting temperature shifts to “L”

side.

[°C]

•

The setting is impossible for fan operation.

NOTE

•

The setting temperature range of the

remote controller is 16°C to 32°C.

ADJUSTMENT

DOWN

UP

DOWN

UP

DOWN

UP

H



M



L

Setting

temperature

25 23 22 21 19

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Comments to this Manuals

No comments