5
/ English
Preparation Before Operation
■
■■
■
Remote controller setup
1 Remote controller preparations
• Battery is already set in the remote con-
troller but the remote controller cannot be
used as is without first preparing it.
Use the remote controller after pulling out
the clear sheet from the battery cover.
2 Remote controller storage
• When the remote controller is not
being used, you can store it in the
remote controller storage slot.
3 Using the remote
controller
• Point the transmitter of the
remote controller towards the
receiver of the main unit.
If an obstruction to the signal,
such as a curtain, exists, the
remote controller will not oper-
ate.
• The distance from which the
remote controller can transmit
is approximately 6m.
4 Battery replacement
1.
Open the cover on the rear of the
remote controller towards the arrow.
2.
Replace the battery with CR2025 bat-
tery.
(Be sure to set the battery with the +
side of the cover as shown in the figure.)
3.
Close the cover to its original position.
NOTE
• Store the batteries where babies and children cannot reach them.
If, by chance, a battery is swallowed, be sure to contact a doctor
immediately.
• When discarding batteries, cover the terminals of the batteries with
tape.
If mixed with other metal or batteries, heat, explosion or combustion
may occur.
• Bring the batteries to a nearby electronics store, watch store or
camera store to recycle them.
ATTENTION
Battery
• The included coin type battery is prepared for initial use.
They will be consumed within 1 year from the manufacturing date of
the air purifier.
• A replacement target is approximately 1 year but if the reception
becomes difficult, replace the batteries with new coin type battery
CR2025.
• Coin type battery close to the “recommended usage period” may
need to be replaced soon.
• In order to prevent malfunctions or injuries due to leaking or explo-
sions, be sure to remove the coin type battery when the unit will not
be used for a long period of time.
Remote controller
• Do not drop or place the remote controller in water.
(Damage may occur.)
• Do not press the remote controller buttons with sharp objects.
(Damage may occur.)
• The signals may not be received well of electronic lighting style fluo-
rescent lamps (such as inverter fluorescent lamps) are in the same
room. For these cases, discuss with the Daikin dealer.
• If other electrical device operate by the remote controller, either sep-
arate them from the remote controller or discuss with the Daikin
dealer.
■
■■
■
Set the filter roll
WARNING
Set the filter while the power supply plug is not plugged in.
CAUTION
• The unit must be operated with a pre-filter and filter roll set.
If they are not set and the unit is operated, malfunctions may occur.
1. Remove the front panel.
• Hold the panel removal knobs (two locations, left and right) and
pull the panel toward you raising it up.
ATTENTION
• Be careful not to scratch the
front or damage the rear pro-
trusions of the removed front
panel.
In particular, the rear protru-
sions function as a safety
switch to turn OFF the power
if the front panel is opened.
If damaged, the unit will not
operate.
2. Remove the plasma ionizer.
• Hold the handle and pull the ionizer toward you raising it up.
Receiver
Front panel
Knob
(2 locations,
left and right)
Rear side
Protrusion
01_EN_3P068886-5G.fm Page 5 Wednesday, December 4, 2002 2:34 PM
(53 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals