9
/ English
Care and Cleaning
■
■■
■
Replacing the filter roll
Replace the filter roll when the “Replace indicator” (Page 4) is lit or
flashes in the main unit display.
Target is once every year.
CAUTION
• The unit must be operated with a pre-filter and filter roll set.
If they are not set and the unit is operated, malfunctions may occur.
• Do not strongly press on the photocatalyst.
The special inverter lamp located inside may be cracked.
• Do not remove the photocatalyst.
• Do not wash the photocatalyst in water.
NOTE
• The replacement period differs depending on the use method
and installation location.
• The replacement period will shorten if the unit is used where
the air is dirty.
1. Stop the operation and unplug the power plug from the
electrical outlet.
2. Remove the front panel.
• Refer to
procedure 1
on Page 8.
3. Remove the plasma ionizer.
• Hold the handle and pull the ionizer toward you raising it up.
4. Remove the old filter roll.
5. Take the filter roll out from the filter roll receiver.
6. Cut off one piece of the filter roll along the perforation.
7. Install the filter roll.
• List up the dark colors of the surface and then correctly insert into
the hooks (four) of the plasma ionizer.
CAUTION
If the front surface and rear surface of the filer are mis-
taken, the performance will drop.
• Store the remaining filter roll in
the filter roll receiver.
NOTE
The filter roll can also be set without being cut. (Page 6)
For this case, you can also replace the filer as shown below.
(1) Remove the filter roll from
the hooks (four) and pull
it out. Then correctly
insert into the next filter
roll into the hooks (four).
(2) Cut along the perforation
8. Install the plasma ionizer in its original configuration.
9. Install the front panel to its original position.
• Refer to
procedure 5
on Page 8.
10. Insert the power plug into the electrical outlet.
11. Press the reset button of the main unit display.
Press using a thin pointed
object to cancel the filter
replace sign.
(A beeping sound will be
heard.)
■
■■
■
Cleaning the plasma ionizer
Clean when the “Clean indicator” (Page 4) flashes in the main unit
display.
1. Stop the operation and unplug the power plug from the
electrical outlet
2. Remove the front panel.
Refer to
procedure 1
on Page 8.
3. Remove the plasma ionizer.
Refer to
procedure 3
on Page 9.
Handle
Filter roll
Hole
Hole
Filter roll
Hole
Hole
Hook
Hook (4 locations)
Dark colored
surface
Hook (4 locations)
01_EN_3P068886-5G.fm Page 9 Wednesday, December 4, 2002 2:34 PM
(53 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals