Daikin R410A Split Series Installation Manual download pdf (Page 15)

13 ■English

Priority Room Setting

• To use priority room setting, initial settings must be made when the unit is installed. Explain the priority room setting, as described

below, to the customer, and confirm whether or not the customer wants to use priority room setting.

Setting it in the guest and living rooms is convenient.

About the priority room setting function

The indoor unit for which priority room setting is applied takes priority in the

following cases.

1-1.

Operation mode priority

The operation mode of the indoor unit which is set for priority room setting

takes priority. If the set indoor unit is operating, all other indoor units do not

operate and enter standby mode, according to the operation mode of the set

indoor unit.

1-2.

Priority during high-power operation

If the indoor unit which is set for priority room setting is operating at high

power, the capabilities of other indoor units will be somewhat reduced.

Power supply gives priority to the indoor unit which is set for priority room

setting.

1-3.

Quiet operation priority

Setting the indoor unit to quiet operation will make the outdoor unit

run quietly.

Setting procedure

Slide the switch to the ON side for the switch that corresponds to the piping connected to the indoor unit to be set. (In the fig-

ure below, it is room A.)

Once the settings are complete, reset the power.

Be sure to only set one room

Priority Room

Setting switch (SW4)

Service PC-board

01_EN_3P164392-2H.fm Page 13 Friday, March 16, 2007 4:26 PM

1 2 ... 10 11 12 13 14 15 16 17 18 19

No comments

Daikin R410A Split Series Installation Manual Page 15