Daikin BRC1E72 Setup Guide download pdf (Page 5)

Page 5 of 36 / OM 1169-1

Remote Controller Installation

Mounting the Remote Controller

Remove the upper case by doing the following:

1. Insert a screwdriver in the recess of lower case to remove

the upper case (2 points), see Figure 3. Remote controller

PC-board is installed on the upper case. Take care not to

damage the PC-board with the screwdriver. Take care that

dust or moisture does not touch the PC-board.

Figure 3: Removing the upper case

Upper case

Lower case

Screwdriver

Insert and twist the screwdriver

lightly for removal.

2. Determine the location where the cabling will enter the

remote controller (back, left side, top left, top center), see

Figure 4.

Figure 4: Cable entry through the back

Back Interior View

Cut-off resin area (hatched area)

Figure 5: Cable entry through left side

Back Interior View

Using an appropriate tool, cut the

hatched area and remove any

remaining burrs

Figure 6: Cable entry through the top-left

Back Interior View

Using an appropriate tool, cut the hatched

area and remove any remaining burrs

3. Determine where to install the remote controller.

Note Remotecontrolwiring2-conductor,stranded,non-

shielded copper/PVC or vinyl jacket AWG18 or 16

Figure 7: Cable entry through the top-center

Back View

Using an appropriate tool, cut the hatched

area and remove any remaining burrs

4. If the control cable for the remote controller is to be

routed from the rear, make a hole in the wall taking into

consideration the location of the access hole in the lower

case. See Figure 8.

1 2 3 4 5 6 7 8 9 10 ... 35 36

No comments

Daikin BRC1E72 Setup Guide Page 5