MODELSRZQ24MVJURZQ30MVJURZQ36MVJURZQ42MVJURead these instructions carefully before installation. Keep this manual in a handy place for future referenc
10[Measures to prevent invasion of small creatures and litter]• Block all gaps in the piping penetration areas with putty or heat insu-lating material
11See the “Service Precautions” label on the back of the front panel for the settings for operation after replenishing refrigerant.1. Open the gas lin
12• The outdoor unit has an inverter which generates noise and charges the outer casing with the leakage current. The outdoor unit should be grounded
13CAUTION• After finishing the electric wiring work, confirm that all the wirings are connected securely.〈〈〈〈〈〈〈〈Precautions when laying power wiring〉
148. CHECKS AFTER COMPLETION OF WORKAfter completing the work, make sure to confirm the following items:1. Connection of drain piping and removal of t
15<Cautions on check operation>• If the air conditioner is started within about 12 minutes after the power of the indoor/outdoor unit is turned
16• There might be a problem with the connection or transmission between the indoor unit and the remote controller.Check connections, and check for wi
1645 Wallace Drive, Suite 110Carrollton, TX [email protected](0510) HT3PN05597-5R EM04A040B00_CV_3PN05597-5R.fm Page 2 Friday,
2SPLIT SYSTEM Air Conditioners Installation manualCONTENTS1. SAFETY CONSIDERATIONS... 22. INTRODUCTION.
3CAUTION•While following the instructions in this installation manual, install drain piping in order to ensure proper drainage and insu-late piping in
42-4 AccessoriesConfirm that the following accessories are supplied.2-5 Main componentsFor main components and function of the main components, refer
5DANGER• Do not install unit in an area where flammable materials are present due to risk of explosion resulting in serious injury or death.• Refriger
6(2)When two or more outdoor units are installed side by side(C) When an obstruction is present on both the air inlet and air out-let sides<Pattern
7•When an obstruction is present also in the upward area(1)When one outdoor unit is installed individuallyThe dimensional relationship between H, L an
85. CAUTIONS ON INSTALLATION• Before installation, confirm the strength and levelness of the founda-tion so that vibrations and noise are not generate
9NOTE• When brazing with blowing nitrogen, set the nitrogen pressure to 2.9 psi or less by using a pressure reducing valve.CAUTION• Do not use anti-ox
Comments to this Manuals