Daikin FTXG50JV1BW Installation Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 17
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
5 English
Preparation before Installation
7) Wear protection gloves and insert both hands under the front grille as
shown in the illustration.
8) Remove the front grille from the 3 upper hooks by pushing up the top
side of the front grille, pull the front grille toward you by holding both
ends of the front grille, and dismount the front grille.
CAUTION
• Be sure to wear protection gloves.
Installation method
1) Install the front grille and firmly engage the upper hooks (3 locations).
2) Install 4 screws of the front grille, and close the 2 screw covers.
3) Mount the flap (small) and return the flaps to the previous positions.
4) Attach the right-side cover. (Refer to figure.)
5) Attach the wire harness to the connector and secure the wire harness
with the wire clamp.
6) Install the air filter and then mount the front panel.
3.
How to set the different addresses
When two indoor units are installed in one room,
the two wireless remote controllers can be set
for different addresses.
1) Remove the front panel and front grille.
(4 screws)
2) Cut the address jumper (JA) on the printed
circuit board.
3) Cut the address jumper in the remote
controller.
4.
When connecting to an HA system
(wired remote controller, central remote controller etc.)
Removal methods of metal plate
electrical wiring covers
1) Remove the front panel and front grille.
(4 screws)
2) Remove the electrical wiring box. (1 screw)
3) Remove the 4 tabs and dismount the metal
plate electrical wiring cover (A).
4) Pull down the hook on the metal plate
electrical wiring cover (B), and remove a
single tab.
5) Remove the 2 tabs on the top part and
dismount the metal plate electrical wiring
cover (B).
Upper hooks
2) Pull toward you.
1) Push up.
1
2
JA
[Indoor unit]
<Bottom of electrical wiring box>
INTELLIGENT
EYE sensor
ADDRESS
EXIST
CUT
[Remote controller]
Jumper
ADDRESS : JA
EXIST : 1
CUT : 2
Metal plate electrical
wiring cover (B)
Metal plate electrical
wiring cover (A)
Screw
[From back side]
Single tab
Pull down
01_EN_3P255640-2B.fm Page 5 Wednesday, January 5, 2011 8:52 AM
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

Comments to this Manuals

No comments